Search models, users, collections, and posts
Multiboard cable and PTFE holder (/guide)
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
4.9 h
2 plates
Open in Bambu Studio
Boost
36
138
16
9
163
75
Released
Description
Simple model to hold and guide cables or PTFE tubes on your multiboard. Just push your cable/tube into the slot, then secure the holder.
Print with 0.2mm layer height.
Credits to Jonathan (KeepMaking) for creating multiboard. Also credits to @svierq for creating a similar version for the honeycomb storage wall - this was my inspiration, although I did not use the honeycomb models.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)