Search models, users, collections, and posts
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
6.7 h
4 plates
0.16mm layer, 2 walls, arrangement and orientation modified
6.4 h
5 plates
0.2mm layer, 2 walls, 15% infill
41 min
1 plate
Open in Bambu Studio
Boost
1046
2414
172
95
2 k
1.1 k
Released
Description
The model was redesigned using nurbs, I tried to keep it as similar as possible to the original.
Changes:
- Head is empty, to allow the insertion of the lamp and to allow the illumination
- Added a screw mechanism to insert/replace the bulb
- Added interlocking joints to facilitate precise gluing of parts
Non-printable material needed:
- Lamp holder (E14 socket) - example link
- Light bulb (E14 socket) - example link
- Hollow screw for chandeliers M12x20mm - example link
- Cable for lamps - example link
- Any type of strong glue (I used a neoprene glue, but a cyanoacrylate glue works just as well).
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (172)