Mark7 Apex10 Ammo Offloading Chute

This is a basic ammo offloading chute for Mark7 Apex10 press.

It has a 63mm output (Outside diameter) for fitting a pipe to it. I ordered this pipe from Aliexpress, and its a very snug press fit onto the output: https://www.aliexpress.com/item/1005007345617628.html?spm=a2g0o.order_list.order_list_main.120.6df61802XCdA5y
If you order the same item, select the one marked as “OD63mm”. Even though it says its OD is 63mm, 63mm actually fits inside..

This just slides over the plate that the ammo bin would usually hang off of.

This is my first model on makerworld. It wanted a 3mf file, I just chose the settings I usually use, so ymmv.
Bambu will say there are unsupported area's, its just the text. It still prints fine with no supports, a few loose strands in the text, but nothing major. (As can be seen in the pics)

Cheers