Magnetic Lid Guitar Pick Case Version 2

Description: A second version of the guitar pick box I made. Compared to the first version (which is also uploaded here), this one has a taller lid, so one has easier access to the picks. I've again made two versions, one for picks up to 1.5 mm (holds 15) and one for picks up to 1.0 mm (holds 17). Since I don't have that many thick picks, I've mostly printed the 1.0 mm version, which is the one in the print profile.

Print parameters: I printed it on my P1S, 0.4 mm nozzle with 0.16 mm layer hight and three walls. No support, no brim, just print laying on the flat face. Infill was set to 15% Gyroid. The print was done in sequential mode on one plate (lid first). I've printed mine in grey Bambu PETG HF, but it will likely be just fine in PLA.

Assembly: After printing the box and the lid, you'll need 4 small magnets (6 mm diameter, 2 mm thickness). I got mine in a 100 pack online, but the ones listed below also have the right dimensions. The magnets are press-fit, I didn't need any adhesive. I found it simplest to lay the lid on a firm surface and press the magnets in. Afterwards i just put an extra magnet on top of each of the lid's magnets and pressed the lid onto the case to insert the magnets.