Tea Towel / Hand Towel hooks

This hook is heavily inspired by (and attributed to, shared alike) the “The GREATEST Towel Hooks v2” by Andor_Yoko. The differences are -

• Two hooks on a 16 x 5cm base
• Attached to wall via screws. The screw holes are countersunk 3mm and hidden by the towels once hung.
• A complete ground-up redesign, with a more rounded look.

Printing

This is a simple print with no support needed. 2 thick walls and 15% infill is fine. I used standard PLA, which seems plenty strong enough.

Usage

Install : Use a pencil to mark the two holes on the wall, and drill small pilot holes. Screw onto wall or side of cabinet. 

To hang towel :  Slightly bunch up towel and slide into slot from the top. It is very easy once you get the hang of it.

To remove towel :  Lift up out of slot. Don't try and pull it through down.

This is intended for smaller towels - face, hand or dishes. It will not work well with full sized bath towels or beach towels. 

Safety, Liability and Distribution Rights
I do not accept any liability for the use or misuse of this item. No guarantee or warranty is expressed or implied. If you do not wholly accept all risks yourself, do not use this item.

This is free to use for non-commercial purposes (licensed under Creative Commons – Attribution – Non-Commercial – Share Alike).

Final Thoughts

• I have other designs uploaded too, so please check out my other stuff!
• Please leave a like & comment if you think this is cool, thanks!
• Check out the original model, which you may like better.