Print the Q-version Deadpool without AMS, print in separate parts

I'm glad you're interested in my model. It supports printing on all sizes of printers (including A1 mini), and it's already divided into separate parts so you can print without AMS.

Before printing, I'd like to tell you about some potential issues with this model:

1. Deadpool's head might have a lot of supports at the bottom, which may not be smooth, but it won't affect the assembly effect.

2. The supports on the clothes need patience to remove, otherwise they are easily broken!

3. The model is basically divided into separate parts, because I put multiple parts on the same print bed, the printing failed. Printing each part separately greatly reduces the probability of failure.

4. The 06 disk has two colors (black and white). I have set a manual pause at the appropriate place. Those without AMS can manually retract the filament and then feed it again.

5. I printed using PETG materials from Tianrui and R3D. The overall print has a shiny feel. If you use PLA for printing and encounter any problems, please feel free to discuss them.

The assembled model is 130*125*236mm in size.

Regarding the nozzle and layer height, I initially used a 0.2mm nozzle with a 0.06mm layer height. However, the printing speed was very slow. Later, I switched to a 0.4mm nozzle with a 0.08mm layer height. I found that the print quality didn't drop significantly, but the printing time was greatly shortened. You can adjust the layer height according to your needs.

If you like it, please give it a thumbs up, comment, and boost me. Thanks for your support!