Feet for 11kg gas bottle

3 of these feet are required for a gas bottle at minimum. I printed them from TPU. Unfortunately, it seems that all gas bottles are slightly different, which is why I printed several sets and scaled them up by 5% in the slicer.

I recommend printing the parts standing on one of the short sides, only then it will be clean and without support.

Advantages of these parts: The floor in the camper is protected (as you can see in the picture, a rusty imprint had already formed). Also, this allows you to move the bottle better without the Truma LevelControl, which is located under the bottle, dragging across the floor.