Search models, users, collections, and posts
Arduino NANO + MCP23017 board holder
IP Report
Print Profile(1)
0.6mm nozzle, 0.18mm layer, 2 walls, 15% infill, pla+
Designer
31 min
1 plate
Open in Bambu Studio
Boost
1
5
0
0
8
2
Released
Description
I designed a holder for 1 arduino NANO and 1 MCP23017 expansion board. The mcp fits very snugly and will stay in place but the nano sits loose. You might wanna put a mall dot of glue on the corner on 1 of the feet of a tiny strip of tape. I might design a small lid to hold them in place in the near future.
There are 3 holes for small screws and i drill them out + tap them for m3 bolts
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)