German Helmet Stahlhelm WWII Bottle Cap

Which printer are you using and with which software did you print

It would have been nice if they had asked first before rating badly directly

You are right. That was not okay of me. I apologize for that. I have a Bambu A1 and generated the print plate via MakerWorld in Bambu Slicer and sent it to the printer. The sliced file looks quite good, so I don’t know why it tears off or prints offset. I just printed another part—no problem. Well, it wasn’t meant to be. And why I didn’t contact you: Well, you are level 30 and a true professional, you earn something extra with this, if every novice who has a printing error contacts you—you wouldn’t want that either. So no hard feelings, now I have corrected it—it sometimes annoys me with my things too—let’s forget about it.

Thanks that makes me happy I was just wondering why there were only 3 stars but now 5 stars are there....thanks

That was a mistake with the 3 stars Fat fingers or Bambu Lab automatically because of the first abort I had changed the support structure after the first attempt which ran for 5 minutes 1 layer 10mm contact area Great project from you ;-)

Many thanks...👍🏻

Thank you, thank you However, it is not intended for opening bottles, but only as a cap

You're welcome, in this case it perfectly serves its purpose Great file, I liked it

danke danke

Gorgeous color

I am currently optimizing the supports for all the helmets, but it will take a little while until I have processed them all

Thank you for your feedback 💪👍

You're welcome…however, I can't promise it will be perfect…it's a very small, complex model with many edges and corners…but I'll try

Fantastic and superb beer 💪🏻

Thank you 😁

geil

🤣🤣

Interesting alignment, look good

thx