Truck with snap-on upgrades

My son came up with the suggestion to create a truck after I created a gantry crane with containers for him. Who am I to say no?

Features

• inspired by the classic Peterbilt 379
• fully printable and to be assembled with concealed swallowtail - and snap connections
• requires almost no support to print
• optional upgrades snap on and off mechanically
• rugged design with rounded edges
• custom ball bearings for decreased rolling resistance
• support for TPU tires
• a lot of details added since v1, including open cabin windows and decorative tail lights on the truck

🏗️ Snap-On Upgrades Available Now, including a trailer and containers! Please check my collection here: https://makerworld.com/collections/6062435 

There's also a Radio Controlled and XL version of this truck available

Troubleshooting:

• Assembly: please follow the assembly instructions closely. Some pieces can be hard to remove when assembled incorrectly or in the wrong order
• Tight fittings: some of the swallowtail fittings are tight on purpose. If you experience challenges during assembly, apply little bit of force and wiggle the piece while sliding it in the fitting
• Bed adhesion: some of the plates have pieces pretty close to the bed’s edges. This can result in poor bed adhesion and curling edges on your print. Make sure to clean your bed before printing and if need be, reduce print speed to 50%. This can be done on the printer display