Perrin Aybara Mah'alleinir

Perrin Aybara from the Wheel of Time book series. This incredible image depicts Perrin holding Mah'alleinir, the first power-wrought weapon to be made since the trolloc wars.

The pictured Frame is from @CanadianGamer - friction Fit design for 200x200 Hueforges

https://makerworld.com/en/models/559845#profileId-479071

In my print profile I have used a height range modifier (HRM), which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Basic Blue Gray
PLA BambuLab Matte Scarlet Red
PLA BambuLab Basic Orange
PLA BambuLab Basic Yellow
PLA BambuLab Basic Silver
PLA BambuLab Matte Ivory White

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Scarlet Red
At layer #14 (1.2mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow
At layer #19 (1.6mm) swap to Silver
At layer #21 (1.76mm) swap to Ivory White for the rest.