Search models, users, collections, and posts
Filament Drying Hood
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 25% infill
Designer
14.2 h
2 plates
Open in Bambu Studio
Boost
2
9
0
0
15
3
Released
Description
Content has been automatically translated.
Introduction:
1. The filament drying hood is suitable for drying filaments on the Bambu Lab A1.
2. Drying time will be slightly longer than professional drying boxes. The specific time depends on whether the hygrometer reading reaches your target.
3. The size of the filament to be dried is less than φ200×67mm.
4. The hygrometer can be purchased online. You can also use my link (I do not sell hygrometers, the recommended link is just because it is cheap and easy to use).
Hygrometer link: Electronic Thermometer FY-11 Electronic Hygrometer Digital Thermometer Digital Temperature Meter Digital Humidity - Taobao (taobao.com)
Note: Not suitable for Bambu Lab A1 mini (the print plate is too small)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)