Fountain of Mystery

Print Profile: Fountain of Mystery HueForge

Project File: Fountain of Mystery
Print Size: 200x200mm 
Layer Height: 0.08mm
Base Layer Height: 0.16mm
Infill: 100% Rectilinear
Min Depth: 0.48mm
Max Depth: 2.2mm
Actual Depth: 2.3mm

Filaments Used:

1. PLA Generic Black
2. PLA Generic Gray
3. PLA Generic Light Gray
4. PLA Generic White

(Feel free to use other colors & or brands to achieve different end results - Swap silver out for light gray if silver is not readily available - or substitute silver for any of your preferred colors to achieve awesome custom end results)

[ COLORS WILL APPEAR ON MODEL AFTER SLICING ]

Layer Swap Instructions:

1. Start with: Black
2. Layer #8 (0.72mm): Swap to Gray
3. Layer #9 (0.8mm): Swap to Light Gray
4. Layer #11 (0.96mm): Swap to White

Note: You may increase the layer height for any sections below the minimum depth of 0.48mm for faster printing, but ensure all layers above this depth adhere to the specified layer height settings.

• (If you decide to scale up or down only alter the X and Y specifications, DO NOT change Z height)

This print requires precise filament changes to achieve the desired color gradient effect in the finished piece. Ensure proper filament loading before each swap point to maintain consistent quality.

Happy Printing!