Search models, users, collections, and posts
Conrail Railroad Coasters
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
12
21
6
2
26
11
Released
Description
Consolidated Rail Corporation - CONRAIL Railroad Coasters
These coasters are 89mm square and 3mm thick.
This print profile worked just fine on my X1C but you may find better settings.
I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will most likely have to trim them slightly. https://a.co/d/0PjaF1i
If you like railroad coasters, take a look at my other railroad coasters and clocks at https://makerworld.com/en/@railimages
I would appreciate it if you could rate my print profile and model, and maybe even leave a boost. Thanks and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)