Search models, users, collections, and posts
Flash card holder
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
27
56
8
7
162
95
Released
Description
I've been working on the CS50 course by Harvard and I've used flash cards quite a bit so I made this holder for them so they're not always sliding around on my desk. It uses standard 5x3 inch cards. I hope you like the model!
I used the standard extra draft profile. (0.28mm layer height)
Boost Me (for free)
Boost this model if it helps you or if you just think it's awesome!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (8)