JBL Charge 3/4/5 Wall Mount (READ DESCRIPTION)

My parents needed their speaker mounted but didn't want to have big hooks sticking out of their wall. I designed this speaker mount where you can slide the hooks in and out of the wall brackets for them and printed with SUNLU PETG since it was meant to be mounted outside.

The margins where the 2 parts slide are a lot larger than I normally would design for if I printed this in PLA. If you print this in PLA keep in mind that it could be that the margins are too big and that there could be quite a big gap between the 2 parts! On top of that I use a custom PETG preset too print so it might print a little different with your own preset! I used 4mm screws to mount the 2 wall brackets into the wall.

MakerWorld doesn't allow me to upload a custom profile (logically) so there is no print profile available

If anyone does end up printing it in PLA let me know how the print ends up and if the margins are okay or if they are too large.

Thanks! :)