Search models, users, collections, and posts
Needle threader
IP Report
Print Profile(1)
0.1mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
Open in Bambu Studio
Boost
32
89
2
1
49
10
Released
Bill of Materials
List other parts
- 0,25 mm (or smaller) wire x 1: approx. 7 cm
Description
I've used 0,25 mm Kynar electrical wire.
- Must be printed at 0,1 mm layer height to preserve wire channel size.
- Set a pause at 1,80 mm layer.
- Make a 0,8 mm loop at both ends of the wire. Wrapping once or twice around small tweezers should be enough.
- Put the wire during the pause with the ends inside the hole. Make sure it doesn't protrude the sides of the hole.
- Resume the print and the wire will be closed inside.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)