Minnie Mouse vase!

The model looks good, however, it is advisable to create your own print profile. The model has far too little infill. The support structures are too tightly attached and are difficult to remove. When you try to detach them, it sometimes tears holes in the model because the walls are too thin. All in all, unfortunately not such a beautiful result. I would like to print it again with different settings, but unfortunately I don't have any more material in that color because I wanted to use up the leftovers..

Looks lovelyand gf loves it but had afew issues which could be due to my filament as its a silk pla(pic of the inside) - under the right bow some of the print was ripped off with support so be careful

Printed with PLA and subsequently clear coated

the supports busted holes in the bow when I removed them and one of the ears didn’t print correctly. I’m newer at printing so there might have been an issue on my end. overall still pretty

looks amazing, the wife loves it, but sadly the supports stuck way too well and we're extremely hard to remove, ended up causing damage to it, also little defect in the smoothness of the bottom

my wife wanted me to print this and it would have been perfect if I hadent used filament that had been sitting out for a few days

I loved printing it, but I had problems with the ears, the bow, and the back of the piece, but I adapted it and it doesn't lose its vase function

🙏

Adorable! The walls are thin and the braces hard to remove. still really cute!

It looks fantastic! I personally will print it again, with three or four walls, as the pattern is somewhat see-through