Print Profile(1)
Description
This is a snap-in holder for water bottles typically used for the likes of guinea pigs, rabbits, hamsters and so on. When you need to clean or fill up the water bottle, simply pull it out of the holder.
When you insert it back in again, first put the spout through the cage at the appropriate height then snap in the bottle.
The whole operation is made with one hand.
This particular holder was printed and tested for the “Classic Midi 320ml” bottle, but the holder would most likely work for other brands with diameter 55mm even if I can´t guarantee it.´
Material: PET-G. PLA can also works but I prefer PET-G for the flex.
I also made other holders for other bottle sizes. If you need a print profile for one of the following bottles, just send me a message and I will make the model public:
- Classic Small 150ml, diameter 41mm.
- Classic Midi 320ml, diameter 55mm.
- Classic Large 600ml, diameter 66mm.
- Trixie 125ml, diameter 47mm.
- Trixie 250ml, diameter 58mm.
- Trixie 500ml, diameter 69mm.
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (50)