Search models, users, collections, and posts
11 tooth gear
Remixed by
IP Report
Print Profile(1)
0.08 mm layer, 2 walls, 95% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
2
5
0
0
22
7
Released
Description
This is an 11-tooth spur gear that I modified for use in my salad spinner.
The original design was a 12mm 11-tooth gear with a 5mm bore created by Matthew Henry (available at www.printables.com/model/310372-12mm-11-tooth-gear-5mm-bore).
I made adjustments by adding a central bore to the gear. For best results, I recommend printing with a 0.08mm layer height and a 95% infill percentage for high quality and better durability.
I tested it with PLA filament, and I can confirm that it works perfectly.
Special thanks to Matthew Henry (www.printables.com/@MatthewHenry) for the design!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)