Dremel Bit Storage - Gridfinity (with pin)

This is a remix of the excellent Dremel storage solution but with the bottom replaced with a bottom for the gridfinity with pin solution to make it compatible with this system as well. It can be use on standard gridfinity or the gridfinity with pin which allows it to click in place and doesn't require magnets to hold it down.

As per the original design:

Description

Two versions are available, one that fits all accessories of the 100pc Dremel accessory set (723-100), and a larger one that fits some additional accessories (pictured). Below is listed what each one fits:

Gridfinity Dremel Bit Storage (3x3u)

• Polishing Pads 414 (10x)
• Polishing Pads 429 (7x)
• Polishing compound 421 (1x included in 723-100 set)
• Sanding discs 411/413 (20x)
• Sanding cylinder 431/438 (8x)
• Sanding cylinder 408/432 (6x)
• 38mm cutting disc SC456 (8x)
• 24mm cutting disc 409 (~36x)
• Small spanner (1x)
• Standard collar bits (amount depends on which bit)

Dremel Storage XL Gridfinity with pin (4x3u)

• Polishing Pads 414 (10x)
• Polishing Pads 429 (7x)
• Polishing compound 421 (1x retail size)
• Sanding discs 411/413 (20x)
• Sanding cylinder 431/438 (6x)
• Sanding cylinder 408/432 (4x)
• 38mm cutting disc (18x)
• 32mm cutting disc (~10x)
• 24mm cutting disc (~10x)
• Small spanner (2x)
• Precision Drill set 628 (full set)
• Keyless chuck 4486 (1x)
• Neck collar standard (1x)
• Neck collar 43mm (1x)
• Standard collar bits (amount depends on which bit)

Gridfinity with pin base system is here:

https://makerworld.com/en/models/440624#profileId-346300

Collection of other great solutions compatible with the pin system is here

https://makerworld.com/en/collections/1143270

Print Instructions

• Filament : PLA works really well I've not found a need for stronger, but you could use anything
• Infill: As per profile works great but you can easily reduce it by a few percent as nothing is under stress with this
• Drying: Always well worth drying your filament whatever it is, you will get better results with dry filament!