Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
5.2 h
2 plates
Open in Bambu Studio
Boost
20
57
6
7
107
83
Released
Description
Lettuce Grow is a nice hydroponics system, but I needed plugs for the unused ports, instead of using pots with dirt.
When a port is empty, you lose more water through evaporation, and small droplets escape.
Simple design, single ones take about 20min. I made it out of PETG, because of light exposure…but likely PLA would be fine.
The plugs are not contoured. I tested on one plug; 190F in the oven for 5min, and the plug can be formed to the system….but not required to function. The plug is deep enough and with gravity, they stay just fine.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)