Cat Water Dispenser

This is a small bowl automatic water dispenser.

Suitable for most standard 28mm water bottle mouth mineral water bottles such as Nongfu Spring, Yibao, etc.

Note that carbonated beverage water bottles such as cola involve internal pressure, and the rim of the water bottle is different from that of mineral water bottles, so this model is not applicable. I also have a version that is suitable for cola bottles, but I think it is unhealthy to give cola to cats, so I did not upload it (=￣ω￣=). If you need it, please leave a message.

The purpose of making a small bowl is to prevent some clumsy cats from getting their entire chin wet or half of their face wet when drinking water from a large bowl, like my Garfield cat at home.

This can also stimulate the cat's competitiveness and achieve the goal of making it drink more water (the cat's heart says: Hey, how come I can't finish licking all this water! * ￣︿￣), and it can also prevent excessive exposure to water from breeding bacteria.

You can use it by printing only the model body. If you are worried about splashing water and wetting the floor, you can print the drain board and water basin.

The model can be used in actual testing without adding any support during the printing process, and there is no water leakage problem with a layer height of 0.2mm. However, for safety reasons, it is recommended to print with a layer height of 0.12mm or less.

Due to the issue of thread strength, it is recommended to use PETG material for printing.

The legend after Figure 4 is not related to the model, only showing off the cat.