Search models, users, collections, and posts
DIRECTV Gemini Streaming Box Wall Mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
56 min
1 plate
Open in Bambu Studio
Boost
11
17
3
0
43
37
Released
Description
This is a print for the DIRECTV Gemini streaming box. Its not for the dongle, but the larger powered TV box. This can be hung on the wall with two screws while also allowing access to all the ports on the back. Modified an ethernet switch design to fit the dimensions and height of the Gemini. I have printed over 100 of these in PLA without issue. No supports are needed. PETG should work just as well, but I haven't tried it. The print in these pics is a quick draft print; the standard settings on a P1S are clean, with very few layer lines. Hope it is helpful-
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (3)