Search models, users, collections, and posts
4080 or 8080 simrig cable management
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.7 h
3 plates
Open in Bambu Studio
Boost
72
280
21
7
202
140
Released
Description
Flexible cable management for xx80 profiles. 200mm, 100mm, and 50mm for varied run lengths.
Mostly intended for simpits but anything that uses xx80 profile and has cables can benefit. Saw a few other models for different profile sizes that I liked, but I needed it for 80mm profiles and had a few other design requirements.
- Print easily (minimal supports, no special tuning, etc)
- strong and flexible
- Easy to put on and take off incase I need to re-cable anything.
I designed these in fusion and am happy with the results. Can fit 3-8 cables, depending on how chonky they are. Print as many as you need and cover all long runs of your simpit for a super clean (and safer) install.
It's probably painfully obvious, but I'm not an engineer and mostly been learning CAD through designing little projects for the house. Constructive feedback and requests help me learn, the more the merrier.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)