Search models, users, collections, and posts
Sony PVM Rubber Isolation Foot
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
35 min
2 plates
Open in Bambu Studio
Boost
1
10
1
1
9
4
Released
Description
Description:
A direct replacement for the Sony PVM-14L5 rubber isolation feet. This will also fit other PVMs such as the 20M4U and 1954Q.
Printing:
- Foot: Use FlashForge ASA or equivalent alternate.
- 0.4mm Nozzle, 0.2mm height, 50%+ infill, 3+ walls.
- Alternate materials such as PC, PETG or PLA would work too.
- Insert: Use PolyMaker PolyFlex TPU or equivalent alternate.
- 0.4mm Nozzle, 0.2mm height, other settings are not very important.
Assembly:
- Insert rubber into the foot, it should be a snug fit but optionally glue can be used to ensure it does not fall out.
- Use an M4x14mm through 18mm screw to install.
Note: Amazon links are affiliates.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)