Aricebo reply - Hueforge

Aricebo message printed with Hueforge.
You will need 7 colors for this, the lowest TD you have, the best result you'll get : )

The 3mf already has all the layer swaps in place, but if you wish to reproduce it using the stl, here are the instructions :

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 49.36x150mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 2.7mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.1
PLA BambuLab Basic Magenta Transmission Distance: 3
PLA PolyTerra Army Red Transmission Distance: 0.3
PLA BambuLab Basic BambuLab Green Transmission Distance: 2.1
PLA BambuLab Basic Yellow Transmission Distance: 5.2
PLA BambuLab Basic Cyan Transmission Distance: 1.7
PLA BambuLab Matte Ivory White Transmission Distance: 3.4
This print uses 7 unique filaments

Swap Instructions:
Start with Charcoal
At layer #6 (0.56mm) swap to Magenta
At layer #10 (0.88mm) swap to Army Red
At layer #11 (0.96mm) swap to BambuLab Green
At layer #17 (1.44mm) swap to Yellow
At layer #24 (2mm) swap to Cyan
At layer #28 (2.32mm) swap to Ivory White for the rest.
 

Happy printing !