Smith3D Malaysia

cover

Cat Pen Holder V2.jpg

cat pen holder.jpg

plate_1.png

5918074392968021236.jpg

5918074392968021238.jpg

5918074392968021237.jpg

5918074392968021235.jpg

2024-08-19_25fbdd4d8d936

Using Arachne Wall Generator saves some filament waste in this case, Aligned seam for minimum seam visibility, 0.28mm layer height for faster print, 2 walls ,5% infill , Slowed down 1st layer speed for better adhesion, tested to work on the A1 mini&nbsp;

Arachne+Aligned seam+0.28mm layer, 2 walls,5% infill,A1 mini

macke

IMG_2856.jpeg

IMG_2860.jpeg

IMG_2862.jpeg

2024-08-31_ccd8d6dc2e947

Scaled up S3Ds <a target="_blank" rel="noopener noreferrer" href="https://makerworld.com/en/models/592304#profileId-518731">Print profile </a>and added Fuzzy skin to make it look less 3d printed.<ul><li>Aligned seam for minimum seam visibility</li><li>0.28mm layer height for faster print</li><li>2 walls&nbsp;</li><li>5% infill&nbsp;</li><li>Slowed down 1st layer speed for better adhesion</li><li>Scaled up 1.5</li><li>Fuzzy skin 0.2 distance and thickness for more organic look</li><li>tested to work on the A1</li></ul>

0.28mm layer, 2 walls, 5% infill, Scale 1.5, Fuzzy Skin

VaderAG

Screenshot 2024-10-25 090236.png

IMG_20241024_192409.jpg

Love the design, but it seemed very wasteful on filament in it's original form The original used about 240g of filament and with this profile it will use around 138g - about half&nbsp;The bottom uses a fairly robust 25% gyroid infill to give it some weight at the bottom, but the rest is lightning which leaves it mostly hollow and as you can see, works really well :)&nbsp;

High Quality, Low Filament - 0.12mm layer, 3 walls

William L.

PXL_20250223_010055248.jpg

PXL_20250223_022533968.jpg

The current profiles have issues:<ul><li>uses &gt;100g of filament</li><li>uses &lt;50g of filament is set to draft mode by default and so doesn&#39;t look good (S3D)</li></ul>This profile is based on the one by S3D but set to extra fine for direct printing with Bambu Handy. This results in much less stringing and defects around the ears.

Extra Fine 0.08mm quality, 48g filament

Clem8eggs

1000001742.jpg

This printed great using Overture PLA with the recommended print settings!

0.2mm layer, 2 walls, 15% infill

A Chonky Cat Pen/Pencil Holder for you stationery. No Supports needed, well balanced. Make sure to scale the print by 1.5 when using the STL file, otherwise the print will be much cuter and smaller. Two designs available, make to check both out. A cat for cat lovers!

Cat Pen Holder

Zac’s 3d design projects

2024-08-17_792cbb92743f5.jpg.webp

Cat pen holder - Personalisable

ASIA

Print Profile(5)

Description

Comment & Rating (862)

License

Remixes (1)

Related Models