Stand for FA-18 Hornet Beastmode - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

NyQuin

Art>Other Art Models

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

FIXED - 0.16mm layer, 2 walls, 15% infill

Designer

2.6 h

2 plates

4.4(19)

0.2mm layer, 2 walls, 15% infill

1.2 h

1 plate

5.0(6)

Open in Bambu Studio

Boost

191

448

208

Released

Description

This is a stand I modified to fit the F/A-18 Hornet Beastmode model that can be found here:

https://makerworld.com/en/models/510197?from=search#profileId-426259

NOTE: this stand is a modified version of my F-16 Beastmode stand, which can be seen in the pictures for this stand as I do not have an FA-18 to take a picture with. This was made upon request and has not been fit tested as thouroughly as the other one though it should still produce good results. If any issues are encountered please leave a comment so that I can address and fix them

This print uses negative volumes of the original model scaled slightly larger to create a snug (but not too tight) fit for the FA-18 model. There are two versions of the base available. The one that is included on the first print plate has visible stairstepping but prints much faster and has good tolerance with the arm that holds the plane. The second version has a colored "F-16" text on the first layers and has been edited so that it can print face down with no support. this version may have a tighter fit with the arm than the original due to print orientation. To counteract this I have scaled it to 101%.