Search models, users, collections, and posts
Hard bait lure box
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
4.4 h
2 plates
Open in Bambu Studio
Boost
252
455
32
43
568
282
Released
Description
- This is a hard bait storage container that can be used on both sides.
It can store metal jigs, minnows, egi, etc. that are less than 100mm long.
There are five compartments on each side.
- Each part requires some support due to protrusions, etc.
Please set it by referring to the following picture. 
- The interior of the body parts does not require any support.
Set the threshold angle of the support setting to a low value, such as 10 degrees, to prevent internal support from occurring. - The recommended material is PETG.
It's okay if it's not transparent.
I am not familiar with 3D printing, so it was difficult to print transparently.
However, it seems to be okay because it prints at a slow speed.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (32)