Search models, users, collections, and posts
Nitecore TIP flashlight shell
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
1
7
0
0
8
3
Released
Description
A replacement shell for the Nitecore TIP (V1). 1mm thick, 0.5mm detail, should work on both MSLA and FDM.
No supports needed.
In order to get maximum transparency using MSLA I used a clear resin (Anycubic Clear), printed the object flat on the build plate, cured in water (after washing) and gave it a few coats of clear spraypaint.
The Anycubic clear resin is pretty brittle, so take care not to over-tighten the screws. Siraya Tech Blu would probably be best if you want something tough and transparent, but as I don't have any, I had to make do.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)