Adam

cover

2024-08-15_2tzuajrgr0yu.jpg

2024-08-15_3b037g1jdzuj.jpg

plate_1.png

5920333227938140288.jpg

5920333227938140287.jpg

2024-08-20_9b51bfef7115c

no glue needed - used PLA pro, 0.2mm layer, 2 walls, 15% infill, slowed down 1st layer speeds for better adhesion, A1 mini

no glue, 0.2mm layer, 2 walls, 15% infill, A1 mini

plate_2.png

plate_3.png

Onkel Jürgen

e3424e30-14cd-11f0-b9f3-d3a5951f6681.webp

Verbessertes Druckmodell um keinen Müll zu produzieren. Sowie verbesserte Augen. Die Augen werden separat gedruckt um keinen Müll zu produzieren.  Die Pupillen werden ebenfalls separat gedruckt und werden anschließend verklebt. Die drei Platten können auf 2 Stück reduziert werden wenn man die Augen zusammenschließt und die Pupillen zusammenschließt als jeweils ein Teil. (Beide Teile markieren und Rechtsklick, Merge) anschließend auf der Platte auswählen „nach Objekten drucken“  So kann man das ganze in nur zwei drucken nochmals reduzieren.  Ist aber nicht zwangsläufig nötig. Die einzelnen Drucke für die Augen dauern nur wenige Minuten. &nbsp;0.2mm layer, 3 walls, 10% infill

Improved print model to eliminate waste. Enhanced eyes as well. The eyes are printed separately to avoid waste. The pupils are also printed separately and then glued on. The three plates can be reduced to two if you close the eyes and pupils as single parts each. (Select both parts and right-click, Merge) then select “print by objects” on the plate. This further reduces the print to only two parts. However, this is not strictly necessary. The individual eye prints only take a few minutes.&nbsp;0.2mm layer,3 walls,10% infill

3 Color,No AMS, Better Eyes

dumb designs

IMG_3633.jpg

2024-08-28_f905cae48fbf8

AMS REQUIRED - 2 color0.2mm layer,&nbsp;2 walls,&nbsp;10% lightning infill&nbsp;

AMS REQUIRED - 2 color, 0.2mm layer, 3 walls, 10% infill

IMG_3752.JPG

2024-08-28_32d22c9bbc88c

WARNING: XL CRABBY MAKES LOTS OF POOPSTypically this can be mitigated by flushing to infill, but there's not much infill to flush to so it has to color change a lot… This is a bigger print of my other profile where I colored the eyes. 2 Color XL&nbsp;0.28mm layer2 walls5% infill

AMS REQUIRED - 2 Color XL - 0.28mm layer, 2 walls, 5% infill

<boostme><boosttitle>Boost Me</boosttitle><boostcontent>If you appreciate the work i do, consider leaving me some boost. Thank you!</boostcontent></boostme>I recommend printing the 3mf since it has all the models in the correct orientation. You can also scale the model to your liking.&nbsp;Assembly is just inserting the 2 pins in the holes and putting the top on. The side the top is facing doesn&#39;t matter since the bottom is symmetric. I didn&#39;t needed to use glue since the press fit was enough.

Print Profile(4)

Description

Comment & Rating (472)

License

Remixes (3)

Related Models

Crab spoon rest