Ailunce HD1 Exoskeleton
Print Profile(1)
Description
This design aids in preventing accidental manipulation of the dials and buttons on the top and side of the Aliunce HD1 Radio while maintaining a sturdy and low profile form factor without sacrificing the use of the lanyard loop or belt clip.
It is recommended to print this out of ASA or similar weather resistant material and apply a small amount of 3M VHB to the bottom of the PTT guard section to prevent hooking it on the edge of pouches or pockets though this is not necessary.
To apply the Exoskeleton first remove the clip and 2 screws from the back of the radio,then place the exoskeleton at a 35 degree angle from the back with the channel dial coming through the top before firmly rocking the device forward so that it snaps into place. This may take a bit of force but should not feel like you're going to break anything.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)