Creality Space Pi Holder Wall Mount - Free 3D Print Model

Search models, users, collections, and posts

berner.michael

3D Printer>3D Printer Accessories

IP Report

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

A1 mini

0.2mm layer, 3 walls, 15% infill

Designer

6.6 h

1 plate

5.0(19)

ABS print profile, brim+discs, 0.2mm layer, 3 walls, 15% inf

Designer

7.6 h

1 plate

4.3(4)

half cut, 0.2mm layer, 3 walls, 15% infill

7.7 h

1 plate

4.7(3)

Split 0.2mm layer, 3 walls, 15% infill

8.3 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

113

304

454

161

Released

Description

Bought a Creality Space Pi filament dryer and ran out of space.

Made this holder by myself, since I couldn't find any models in the web which were pleasing or precisely fitting to this dryer.

Can be printed on 254x254mm printbeds (e.g. Bambu) if model is laid on its back and rotated a bit. Supports needed. Approximately 200g of filament (150g model, 50g supports). Printed it Gray PLA, which is a great fit to the filament dryer. M5 countersunk screws fit just fine.

It is recommended, though, to print it with more temperature resistant materials, because this bad boy can get quite warm on the outside, especially when drying at high temperatures for very long time. Had to learn this the hard way myself.

Embedded in the Fusion model you can find a variant in the timeline, where the model is split and can be printed without supports, but needs dewels and heat inserts instead. I went with supports.