Search models, users, collections, and posts
Golden Snitch - Magnetic Ring Box/Decoration
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 5% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
267
681
52
38
960
445
Released
Description
Remix from YoyoStudios which in turn is a remix from the original by Porda. I added a slot for a second magnet since it didn't close nicely with just one magnet. It supports 8x2mm magnets. Pluse I made some small modifications to the wings for better printing.
IMPORTANT: The file is ready to print the positioning is important. Make sure the 1st layer prints the entire shape of the wings, if not try lowering the wings 0.02 mm below the bed and check again. I added built-in brim to the tip of the wings since they have problems sticking to the bed.
The stand I made it myself from scratch, you can find it here: https://makerworld.com/en/models/583803#profileId-504951
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (52)