Anycubic I3 Mega S - Pi and cable management

This is a support designed to house a Raspberry Pi 3 and all connection cables for managing temperature sensors, flame detection, relays, and LEDs

In fact, inside the printer I placed this other support:

• https://www.thingiverse.com/thing:4800977
  which allows the integration of:
• Raspberry Pi power supply
• relays for turning the printer and LEDs on and off
• DS18B20 temperature sensor

All connecting cables enter the support through the hole intended for power supply voltage selection

The side walls, lid, and base have special holes to allow the passage of necessary cables, such as:

• Raspberry Pi power USB
• USB for serial communication with the Trigorilla motherboard
• LED strip
• si7021 temperature sensor
• KY-026 flame detection sensor
• other..?

The support is designed to fit into the printer's ventilation holes via small cylinders (or spheres) on one side, and onto the screws and printer profile on the other.
It is necessary to remove and reinsert only the top right screw for better structural fixation

To support the camera, this remix was made:

• https://www.thingiverse.com/thing:4865560
  which modifies the following two projects:
• Pi camera support: https://www.thingiverse.com/thing:3475279
• LED strip support: https://www.thingiverse.com/thing:2797456