Search models, users, collections, and posts
LLG Angled Controller Connector v3
IP Report
Print Profile(4)
PLA Profile
Designer
1.5 h
1 plate
ASA Profile 1% Scale Increase
Designer
1.2 h
1 plate
0.2mm layer, 3 walls, 15% infill, Tree Supports, Brim, A1Mini Optimized
1.9 h
1 plate
0.2mm layer, 3 walls, 15% infill. V3 version to print on A1
1.8 h
1 plate
Open in Bambu Studio
Boost
100
181
130
45
1.2 k
887
Released
Description
This is for the Lenovo Legion Go, not the Switch.
Angled Controller Connector v3
This is a revised version of my original angled grip. I moved from using Tinker Cad to Fusion360 and made a much better latch with stronger teeth and better tolerances.
Filament: PLA/PLA+
Infill: 30%+
Infill Pattern: Cross Hatch
Seam Position: Nearest (don't try to use it as a strength grip, it will snap)
If you're printing with ABS/ASA be sure to account for shrinkage and scale the stl b 0.5-2% depending on your filament. With Bambu ASA I only needed a 1% scale increase.
Tolerances might be an issue on the latch depending on your printer and slicer settings.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (130)