Wi-Fi Controllable Turntable
Print Profile(1)
Bill of Materials
- ULN2003_driver_module x 1:
- 28BYJ-48_stepper_motor x 1: 5V
- WEMOS_D1_Mini x 1: USB-C
- M3_inserts x 3:
- M2_bolts x 4:
- M3_bolts x 5:
- M3_nuts x 2:
- LED x 1: 3mm
- Resistor x 1: ~220ohm
Description
A simple webpage controllable turntable project that I made during a free weekend. The code for this project can be found on GitHub. This turntable should be very cheap to make, I would estimate that it could be less than €4, depending on where the parts are sourced from.
I'm open to suggestions/improvements! 😀
Make sure to check out my other creations on MakerWorld as well👀
General information:
- Diameter: 100mm
- Height: 33mm
- Weight: ~60 grams (PLA)
- Print time: ~2 hours
Required parts:
- Electronics
- ULN2003 stepper driver
- 28byj-48 (5V) motor
- Wemos D1 mini (USB-C)
- 3mm LED
- LED current limiting resistor (220 ohm)
- Fasteners
- 3x M3 threaded insert
- 5x M3 bolt
- 2x M3 nut
- 4x M2 bolt
- 4x M2 nut
Instructions:
- Print the required parts.
- Do a test fit for the component, this also gives you an idea of how long the wiring needs to be.
- Solder the circuit together (see pictures).
- Test the circuit by uploading the provided code
- Mount the components in place. The Wemos and LED probably need a dab of hot glue to stay in place.
- Insert the threaded inserts
- Screw the bottom on
- Place the rotating disk on the motor
- Connect to the WI-FI network “TURNTABLE” (no password)
- Goto 192.168.4.1
- Control the turntable
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (34)