Search models, users, collections, and posts
Quick Hanger (Light, Other, Reptile)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
20
30
4
1
47
36
Released
Description
Simple model, just tossed it together. Not an engineer, unsure of the rating/weight tolerance. I have tested with a Reptizoo dual light.
The hanger would work for many other things. It is about ½" wide and less than 10" deep. 3M Command strips did work for a short time, but the weight didn't hold and I used a screw. Better command strips (higher weight capacity may work).
Black PLA, is generic but I like this brand for simple prints.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)