Ichigo Vasto Lorde

Project: VASTO LORDE 1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 227.2x240mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.6mm and the Actual Depth is 2.4mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Matte Scarlet Red Transmission Distance: 2
PLA BambuLab Matte Mandarin Orange Transmission Distance: 3
PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments

Swap Instructions:
Start with Charcoal
At layer #11 (0.96mm) swap to Blue Gray
At layer #15 (1.28mm) swap to Scarlet Red
At layer #19 (1.6mm) swap to Mandarin Orange
At layer #21 (1.76mm) swap to Ash Gray
At layer #25 (2.08mm) swap to Jade White for the rest.

For those without more than one AMS, either do not load the last Slot A4 putting colors in order of print on the AMS and load the rest of the colors on slots A1 (Grey) and A2 (White) or wait until Black and Blue Gray finish and swap them individually.