Search models, users, collections, and posts
Conch horn
Remixed by
Print Profile(1)
BBL A1|0.8mm nozzle|0.4mm layer height|tree support|brim
25.6 h
3 plates
Open in Bambu Studio
Boost
157
381
29
25
313
121
Released
Description
Print the intricate swirling pattern of the queen conch. Then give it a blow to summon a kraken!
Started with the exterior 3d scan of a queen conch, hollowed out the internals, then modeled a spiral from reference photos of conch shells cut in half. Finally, added a trumpet mouthpiece. With the internal swirl, it sounds almost like the real thing.
This fits an Ender 3 print bed after shrinking the margins a bit – prints as two pieces, Conch_horn_top and Conch_horn_bottom. Also included is a version with a wider mouthpiece.
Differences of the remix compared to the original:
Hollowed inside, mesh adjustments, added a spiral.
Joined trumpet mouthpiece with conch shell.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (29)