Silverline Compartment Organiser Inserts

This is something I designed for myself, but I am sharing because I feel others may find it useful too.

Description

I love the Silverline Compartment Organisers. They are cheap compared to the competition, reasonably well made, and have removable compartments. But the compartments aren’t quite as I want them. So, I designed some replacements.

I use my organisers to store lots of smaller parts, which don’t need a massive compartment. So, I designed a whole set of the 1x1 and 2x1 compartments with dividers so I can make better use of the space. I also added a label shelf which not only allows me to add a 9mm deep TZe label from my Brother label maker, it is also great for grabbing onto to take a compartment out.

Notes

I have included all variations I have made so far, plus a full set without the label shelfs. The 2x1 has five variants (1,2,3,4 or 5 compartments) whilst the 1x1 has two (1 or 2 compartments).

These will fit absolutely fine with the existing Silverline inserts if you don’t want to replace them all. The 2x1 compartments can only go horizontal, as they don't have the ident in the middle.

These will fit the Silverline 8 compartment (252594), the Silverline 13 compartment (248965) and the Silverline 21 compartment organiser (383765).

Printing Settings

I like to print these in PLA, on 0.20 Strength with an adaptive layer height (0.50/5) and an outer brim. This is to ensure the lower corners print correctly, but the print isn’t slowed down too much. If you are using a cheap filament I recommend using ‘normal supports, build plate only’.

Please feel free to like, share or comment.