Search models, users, collections, and posts
Holder for shaker lids
IP Report
GIF
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
17
68
2
2
49
34
Released
Description
This is the best solution I have found to organize all the lids for the protein shakers. It accommodates max 6 lids of various sizes. If you have your strainer connected to the lid it accommodates up to 4.
I have made a rermix of this aswell that is in a hex pattern and uses a little less filament (30g) but takes 3h longer. Check it out aswell! https://makerworld.com/en/models/588777#profileId-510062
If you print it and like it, I would appriciate a boost.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)