Working Headlight Kit - Dummy 13 Dirt Bike

Headlight Kit for Dummy 13 Dirt Bike

Add some illumination to your playtime!

Designed to power a headlight LED, this sleek design fills the void where the motor would go by incorporating a battery pack in it's place. This works off of 2-3 LR44 button batteries. (3-4.5v) This requires electrical and soldering knowledge.

Please proceed with caution.

By continuing with this kit, you agree that:

I, the designer, am not liable for any bodily injury or property damage. You understand that you are solely responsible for any costs arising out of any bodily injury or property damage sustained through participation in the above-named activity.

This kit requires:

• 1x LED light
• 2-3x LR44 batteries
• 1x 220-330 ohm resistor
• 2x Female Jumper wires
• Soldering iron
• Battery Contact plate (Optional, but preferred)
• Switch (Optional, can be unplugged by the jumper wire)

Assembly:

1. The MotoBattPack should push into place, but fits very snugly.

   

2. The female jumper wires should be cut and stripped on one side and fed through the holes in the side

3. Then they should be soldered to the battery connection pads.

   

   

4. Install the LED into the headlight mount
5. Bend the wires to fit in the grooves. (The positive (anode) groove goes further off to the side)
6. Take the LED back out, and solder the resistor to the LED anode. (There is a slot on the longer groove for the resistor to fit into.)

7. Cut the resistor to length to allow a female jumper wire to slide over it in the larger opening in the groove

   

8. Push the mount into place and plug in the jumper wires
9. Install batteries

10. LET THERE BE LIGHT!

    

If you did not include a switch, this can be turned on and off by unplugging the female jumper wire from the headlight mount!

Have fun and keep printing. :)

-tuny

---