D-Line Trunking Cable End Cap
Print Profile(2)
Description
This is an end cap for trunking if you only have one cable inside, it can look ugly if the end is visible.
This simple end cap just pushes into the end and has a slot for the cable the pass through.
It has been designed to be a good friction fit however you can use glue to make it permanently fixed in place if you would prefer.
Required support however due to the small size it only uses a tiny amount of filament and only adds a couple of minuted to the print time.
PLEASE NOTE:
This end cap will only work with the brand “D-Line” trunking in the 30x15mm size.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)