PID and Dimmer enclosure for Vibiemme espresso

This box was developed for a better finish on the installation of a PID (model XMT 7100) and Dimmer in a Vibiemme Domobar.

I printed this one in PETG from Sunlu, using a Sovol SV07 Plus, Cura slicer, 235 degrees, 80 degrees bed temperature, no brim, no supports needed. Other configurations I used: 0.2mm (draft), speed 200 mm/s, acceleration 5000 mm2/s, tri-hexagon pattern with 20% infill density, 2 wall loops. Wall ordering Outer/Inner, z seam alignment: random.

If you are a espresso enthusiast, I invite you to visit my website where I'm building a series of tutorials for dummies: www.espressohackers.com and on YouTube: https://www.youtube.com/@EspressoHackers 

The idea is to make available a high performance espresso machine for the enthusiast at a low cost, but simple enough for anyone to make, not only the DIYers.

Links for parts below:

PID: https://s.click.aliexpress.com/e/_DEjqXdz

SSR: https://s.click.aliexpress.com/e/_DmVB623

PT100: https://s.click.aliexpress.com/e/_DD43ogX

Dimmer: https://s.click.aliexpress.com/e/_Dlpra35

Aluminium enclosure: https://s.click.aliexpress.com/e/_DFB8CUX

Black aluminum enclosure: https://s.click.aliexpress.com/e/_DCXkNzd