Search models, users, collections, and posts
Drill Jig for Deck Balusters
IP Report
Print Profile(2)
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
2
6
0
1
4
1
Released
Bill of Materials
List other parts
- Washers(1/4in) x 4:
Description
Note: It is currently recommended to scale the print between 102% and 105%. The tolerances are extremely tight.
This custom-designed drill jig is the perfect tool for ensuring precise alignment of deck balusters on two 2x4s. It is designed to help you drill pilot holes with a 1/4 inch drill bit, setting the stage for a spade bit afterward. Tailored specifically for 3/4 inch balusters, this jig guarantees a consistent spacing of 3 3/4 inches between each baluster, ensuring a uniform and professional finish to your deck project.
Key Features:
- Material: Recommended to print in PETG.
- Design Compatibility: This was specifically made for 3/4 inch balusters.
- Drill Bit Size: Optimized for a 1/4 inch drill bit for pilot holes.
- Spacing: Consistent 3 3/4 inch spacing between balusters.
Default Profile Specifications:
- Material: Generic PETG.
- Nozzle Size: 0.6mm.
- Layer Stop: The print is designed to pause at layer 26 to allow for the insertion of four washers (two on each side), ensuring stability and accuracy. After placing the washers, the print can be resumed to complete the jig.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)