Zenitsu and the Moon

Before You Print!

If you wish to sell any of these check out my Patreon if you'd like to support my work and get access to sell commercially!

Thank you for supporting me

www.patreon.com/fabricate3dprint

First, You cannot adjust the z scaling on any hueforge. This will mess with the coloring and won't come out right. If you do want it smaller or bigger you can scale the x and y proportionally to the set sizing either by percentage or length.

Each one of my prints will use bambulab filaments unless other wise stated!

Don't worry about what you see in the slicer, it is not accurate to how the final results will look as the colors will blend to make it look proper!

I Provide a .mf file for each one of these posts that is set up and ready to print. Follow the color code provided at the bottom!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 125x250mm in size
You may print at higher layer heights below the Min Depth of 1.2mm
The Max Depth is 3mm and the Actual Depth is 2.3mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Gold Transmission Distance: 2.3
PLA PolyLite White Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #21 (1.76mm) swap to Blue Gray
At layer #24 (2mm) swap to Orange
At layer #26 (2.16mm) swap to Gold
At layer #27 (2.24mm) swap to White for the rest.

TO DO THIS PROPERLY WITH ONLY ONE AMS YOU I ADDED A PAUSE IN THE MIDDLE OF THE PRINT. WHEN YOU PRINT YOU WILL HAVE TO ASSIGN THE EXTRA COLOR TO ONE OF THE COLORS THAT THE PRINT WOULD HAVE ALREADY COMPLETED. WHEN IT PAUSES YOU JUST CHANGE THE COLOR AND PRESS RESUME.