Sports Jersey Wall Mount Hanger (non-damaging)

Hey y'all, I recently had a problem where I wanted to mount my sports jerseys on the wall and looked at potential solutions. There are frames available on the market however, I did not like the look of the jersey inside. There are also solution similar to mine but they're all ridiculously expensive and did not display the jersey in a clean and crisp manor.

So to fix that I hopped on Fusion 360 and after weeks of prototyping tolerances and shapes and sizes, I have happily settled on this design. This design allows for everyone to be able to hang their favorite sports jersey on the wall in a way that is discrete and does not damage the jersey in anyway!

Printing and Assembly:

• Each Jersey Hanger requires a center piece and a number of left and right pieces (left goes left from the center piece when hung)
• Make sure infill and wall counts keep the parts relatively light in order to ensure no damage to the wall
• For the most discrete look, print in a color that either matches the jersey or the wall
• Snap each piece together show in the gif, you can further rotate each piece in four different positions
• TIP- If you use a right piece to go left (or vise versa), you can rotate much closer to 90°. This works well for supporting NBA and basketball jerseys!

This design allows for multiple hanging applications:

• A standard screw with a drywall anchor
• Command Strips (most renter friendly!)

• Push Pin (My personal favorite and shown in the gif below)