Search models, users, collections, and posts
Microphone stand (short and flat)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
58 min
1 plate
Open in Bambu Studio
Boost
15
37
0
1
111
23
Released
Description
I made a microphone stand for my Devine USB 50. The original stand was a little too high for my desk and monitors. I used the same screws and mounting hardware that was provided with the microphone.
I made it with grey and orange because it is easier to spot in the picture. Also my grey filament was almost empty…
Ofcourse it is not a multicolor print and choose the color you like!
Feel free to ask me anything and remix this design.
Boost Me (for free)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)